 |
| Easily adjustable, and no holes that weaken the snath. |
Instructions for making the traditional Russian one-grip snath (with wrap-around grip) were translated in this earlier post. Here's a recap:
The grip is
made from a freshly-cut branch that is bent around the snath and secured
with a piece of twine. Willow or wild cherry is suggested, with a
diameter of 25-30 mm and a length of 350-400 mm. The size of the cutout
portion in the middle depends on the diameter of the snath, but is
typically around 80 mm, with a depth that's less than half of the branch
diameter. A groove is made within the cutout portion, removing the pith
and the center of the branch to accommodate bending without breakage.
Grooves are carved around each end of the branch to hold the twine in
place, once the handle is bent around the snath. A thin piece of rubber
(like a scrap from an inner tube) between the grip and the snath will
make the connection more secure during use.
The drawings appearing above are linked images from the Russian site Pandia.ru and originate from a magazine article titled кoси, кoса by Н. Н. Рoдиoнoв, appearing in the journal Сделай Сам (Знание) 1992-02 [journal name translated as DIY (Knowledge)].With some willow branches from my backyard and a few hand tools, I tried to make one of these Russian snaths, and a couple hours later I was mowing with it. The willow for the shaft had been cut about two years earlier, so it was quite dry and surprisingly stiff. The handle material was cut a few days prior and was kept soaking in a bucket of water until used. I did have some difficulty getting the handle piece to bend sufficiently without breaking. After a few failed attempts, I learned that the central groove in the cutout section needed to be larger than shown in the drawing (at least for the willow I was using), to result in a thinner outside wall that bends more easily. A hook knife was useful for accomplishing this.
Tools used:
- Bow saw -- for pruning the willow tree
- Hand saw -- for cutting the branches to finished length, and for cutting the flat portion where the tang of the blade is clamped
- Mora knives (3) -- straight, hooked (for the handle groove), and double-handled (like a drawknife)
- Brace and bit -- for drilling an indent for the knob of the tang; could have used a knife instead
- C-clamps (2) -- for clamping to a picnic table, instead of using a vise or shaving horse
- (Rasps and sandpaper were not used for this snath.)
Materials used:
- Branches
- Piece of string (from straw bale)
- Piece of rubber (from bicycle inner tube scrap)
In use, I noticed a slight bit of play in the grip; it was not as rock solid as the drilled-and-glued grips on other snaths. I think this could be avoided by doing a better job of carving (to minimize the gaps between the grip and the shaft), and possibly by using a thicker branch for the grip (for more material to resist flexing). For the next one I make, I will try a larger branch for the grip, wider than the 30 mm shown in the drawing, which will be stronger and allow me to carve it down to customize the shape.
Sources:
Article titled «Коси, коса...» by Н. Н. Родионов, from the journal Сделай Сам (Знание) 1992-02, pages 45-69
Reprint and images from the article provided by:
Pandia.ru http://www.pandia.ru/text/77/398/102961.php
Original article appears at:
http://zhurnalko.net/=sam/sdelaj-sam-(izdatelstvo-znanie)/1992-02--num45
